Subject:
|
Re: Update 9904 released
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 25 May 1999 01:21:58 GMT
|
Viewed:
|
717 times
|
| |
|
|
On Mon, 24 May 1999 20:15:06 GMT, "Jeff Stembel" <Dragonelf1@aol.com> wrote:
> In lugnet.cad.dev, Terry Keller writes:
> > LDraw cognoscente,
> >
> > The last voting parts have been released, LCAD9904.
> > Mostly new parts, with a few fixes that didn't make the last maintenance
> > update.
> > The large Technic shock is not included. Still need to figure out how best to
> > release it.
> >
> > http://hugin.risoe.dk/JJ_Memorial/official.html
> > http://www.geocities.com/Athens/Parthenon/2244/official.html
> >
> > Hopefully, everything is OK. Let me know if any problems arise.
>
> I took a gander at the patterned baseplates and noticed something disturbing:
> Half of the (14 existing) patterns don't line up properly. There is much
> variation between line thickness and positioning, and I don't think there
> should be. Most, if not all, of my baseplates line up properly, so I think all
> the baseplates need to be looked at in-depth and a standard set for them.
>
> The ones that seem correct are the four 9-stud road patterns and three of the
> 7-stud road w/sidewalk patterns (the one not included is the straight).
> Luckily, these seven have the same line positioning and thickness, so they're
> okay.
>
> Jeff
You are correct, sir. I was aware of that, and Steve Bliss has already said
he will fix those of his that are in error, as well as an original piece by
James.
At the time he said this, I already had the update all ready to go, and so
decided to go ahead and release it as-is and worry about fixing the alignment
problems in an update.
You are right in suggesting we need a standard. Future baseplates should be
required to correctly align with existing plates. This is something we need to
pay more attention to.
Steve and I have also been trying to standardize the names of the baseplates,
so hopefully we can also fix any alignment problems at the same time.
-- Terry K --
|
|
Message has 2 Replies:
 | | Re: Update 9904 released
|
| (...) If there's any problem with the parts I've done, just tell me and I'll fix them but as Jeff said they line up correctly, the only problem could be the orientation. Leonardo (26 years ago, 25-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: Update 9904 released
|
| (...) I took a gander at the patterned baseplates and noticed something disturbing: Half of the (14 existing) patterns don't line up properly. There is much variation between line thickness and positioning, and I don't think there should be. Most, (...) (26 years ago, 24-May-99, to lugnet.cad.dev)
|
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
