|
|
 | | ERROR in lcad9903 update
|
| Sorry folks, I made a mistake in update 9903. Piece 2429, the 1x2 hinge plate, was overwritten by another part. For an immediate fix, you can download and install this quick fix; (URL) it just like any other update. It contains: 146.dat a ~Moved to (...) (25 years ago, 20-May-99, to lugnet.cad.dev)
| | | | | Re: Part 2429
|
| (...) Joshua's simple typo, but my QA error. I coulda swore I went through all the potential number changes and checked each one for conflicts with existing pieces. Now that the real story is known, I will endeavor to correct the problem ASAP. -- (...) (25 years ago, 20-May-99, to lugnet.cad.dev, lugnet.off-topic.fun)
| | | | | Re: Voting Comments
|
| Steve Bliss skrev i meddelandet <3741a8a1.20817582@l...et.com>... (...) Is that safe for transparent pieces? I toyed a little with re-sorting some parts to 'outside-in' instead of 'inside-out' to make the drawing faster (minimize overdraw), but then (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
| | | | | Spheres in LDLite [DAT]
|
| I just noticed that when I view a sphere in LDLite in a front, side, or top view, half of the edge line is not drawn. This is true in standard or wireframe mode. In LDraw they are all drawn. I did a little investigation, and it appears to be related (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
| | | | | Re: Part 2429
|
| In lugnet.off-topic.fun, Duane Hess writes: DOH! Let's try this again. (...) (25 years ago, 19-May-99, to lugnet.cad.dev, lugnet.off-topic.fun)
|
|
