 | | Re: Voting Comments —Anders Isaksson
|
| | | Steve Bliss skrev i meddelandet <3741a8a1.20817582@l...et.com>... (...) Is that safe for transparent pieces? I toyed a little with re-sorting some parts to 'outside-in' instead of 'inside-out' to make the drawing faster (minimize overdraw), but then (...) (26 years ago, 19-May-99, to lugnet.cad.dev)
|
| | | |
| | | | | Re: Voting Comments —Steve Bliss
|
| | | | (...) Order of drawing doesn't matter, except for coincident objects. For transparent surfaces vs. edges, it matters even less: the edge must 'show through' the surface, or the renderer isn't working right. LDraw and LDLite both display transparent (...) (26 years ago, 20-May-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: Voting Comments —Anders Isaksson
|
| | | | Steve Bliss skrev i meddelandet <37441788.505228@lugnet.com>... (...) Then the rendering *could* be speeded up by resorting everything 'outside-in'? (Smaller number of pixels to change) -- Anders Isaksson, Sweden BlockCAD: (2 URLs) (26 years ago, 20-May-99, to lugnet.cad.dev)
|
| | | | |
| | | | | | Re: Voting Comments —Steve Bliss
|
| | | | (...) Yes, that reordering will render just fine. I don't know how much it will speed up rendering. It would be interesting to find out. Steve (26 years ago, 21-May-99, to lugnet.cad.dev)
|
| | | | |
