|
|
 | | Re: Voting Page
|
| Steve Bliss <blisses@worldnet.att.net> wrote in message news:3741a938.209688...net.com... (...) some (...) fix (...) everyone.. (...) Inlining primitives with type 5 lines works fine. But at least sometimes inlining a subpart has turned the type 5 (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Voting Comments
|
| Is there already a button for this? It had odd results when I tried it long ago IIRC. -John Van Steve Bliss <blisses@worldnet.att.net> wrote in message news:3741a8a1.208175...net.com... (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Voting Page
|
| (...) Hmm. I don't remember hearing about this problem before. Probably did, and it fell out of my brain. I will look into the LDAO/inline code, and see what's up. Steve (25 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Voting Comments
|
| (...) I've thought about writing a function in LDAO to sort a DAT file by line-type: first the 2 (edges) and 5 (conditionals), then the 1 (may be edges, surfaces, or both) then the 3 (triangles) and 4 (quads). Steve (25 years ago, 18-May-99, to lugnet.cad.dev)
| | | | | Re: Part Name Question
|
| (...) I like Bar or support. Those, IMO, are the most-likely non-space use of it. (...) Will the 1x1 end of it use capitalization? (i.e. STUD.DAT) Also, a problem that I noticed with John's mock-up is that the end cylinder was *not* the same (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
|
|
