To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 1767 (-5)
  Part Name Question
 
I'm finalizing the "Star Wars Ion Cannon" part, and neither John nor I can think of a decent name for it. Heck, what *category* should it be in? John has suggested one of the following categories: Bar Support Space And I've got the following (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
 
  Re: new part description changes?
 
(...) Speaking as the author of this part, I like the idea of using the word "Bogie" in the description. But also I would like to express in the name that you normally clip this part on the side of the train motor. So I would prefer the following (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
 
  Re: new part description changes?
 
(...) Either of these is fine with me. (...) The 'without corners' name follows the precedent of existing LDraw pieces: 2450.DAT Plate 3 x 3 without Corner 2419.DAT Plate 3 x 6 without Corners 6106.DAT Plate 6 x 6 without Corner 2401.DAT Plate 10 x (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
 
  Re: Voting Comments
 
(...) You can minimize the jagged appearance by using a 1-8cyli.dat around the hole. This leaves the minimum amount of surface around the holes to be jagged in POV-Ray. And if you rotate all the primitives to center your 1-8cyli parts on the (...) (25 years ago, 18-May-99, to lugnet.cad.dev)
 
  Part 2429
 
What happened to this part (used to be Hinge Plate 1 X 4 Bottom)? Part 146, Window 1 x 2 x 3 Pane Latticed, was move to this number (2429) in the last update, but I cannot find the original 2429. Does anyone have any answers, or did I just miss (...) (25 years ago, 18-May-99, to lugnet.cad.dev)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR