 | | Re: baseplate 32 x 32 road curve with road pattern-9 studs
|
|
(...) In the absence of example, surely you still have common sense to go on? Approximating a very large circle using increments of pi/12 radians either isn't appealing to common sense or shows a lack of common sense. --Todd (26 years ago, 6-Apr-99, to lugnet.cad.dev)
|
| |
| | New metacommand for views?
|
|
I am contemplating making a new metacommand to allow the definition of useful named viewpoints and using them to provide a pop down list of points from which to view the model. Basically these would not be used at all in the rendering process of (...) (26 years ago, 6-Apr-99, to lugnet.cad.dev)
|
| |
| | Utility Spreadsheet
|
|
I posted my little spreadsheet of utilities to (URL) (It's in Excel'97 format) Sheets are included to interpolate a point on a 2D line segment, find the intersection of two 2D line segments, figure out which ring primitives to use for a torus, and (...) (26 years ago, 6-Apr-99, to lugnet.cad.dev)
|
| |
| | Re: baseplate 32 x 32 road curve with road pattern-9 studs
|
|
(...) I didn't use the torus generator program on the new parts. I wrote a couple of Visual Basic routines that I used on the new pieces, which generate circular rings and edges. I've included the routines below, but I haven't done anything to (...) (26 years ago, 6-Apr-99, to lugnet.cad.dev)
|
| |
| | Re: Part Request: 30200
|
|
(...) to (...) Without getting into the metric versus imperial debate again... but using my assumption that the are 64 LDUs to the inch, 0.1325 inches is close enough to 8.5 LDU. Chris (26 years ago, 6-Apr-99, to lugnet.cad.dev)
|
