 | | Re: LDRAW for Mac; was: Mark's Lego Creations Update!
|
|
(...) \/ Ldlite source is available and has been ported to the MAC. It could use an update though. I'm not sure if this is what you're looking for. If you need LEDIT functionality then you're out of luck. Perhaps you could use this as a starting (...) (24 years ago, 3-May-00, to lugnet.space, lugnet.starwars, lugnet.cad.dev)
|
| |
| | Re: Suggestions for new primitives: Flex-System hoses.
|
|
(...) I can do that, and post the results soon on lugned.cad.dat.parts. Note that you will not find any hoses that are exactly 120 LDU long: They normally come in somewhat "odd" lengths. As for the ribbed tube, the best way to find the length of one (...) (24 years ago, 2-May-00, to lugnet.cad.dev)
|
| |
| | Re: Suggestions for new primitives: Flex-System hoses.
|
|
(...) OK. According to Jim Hughes (via the Technica Element Registry) both the flex-system tubing and the corrugated tubing 'are widely available in many lengths'. So should we make a single "Technic Flex Tube" piece, and a single "Technic (...) (24 years ago, 2-May-00, to lugnet.cad.dev)
|
| |
| | MOTM May Winner!
|
|
I'm pleased to announce that the winner for the ldraw.org MOTM May competition is none other than Todd Lehman with his Spider Walker model. Take a look at: (URL) and congrats Todd! -Tim (URL) timcourtne ICQ: 23951114 (24 years ago, 2-May-00, to lugnet.announce, lugnet.cad, lugnet.cad.dev.org.ldraw) !
|
| |
| | Re: Suggestions for new primitives: Flex-System hoses.
|
|
(...) That would be great! I have worked a bit on them myself. Here's what I have done so far: (URL) used two sub parts for the ribbed hose: end and segment parts. Look for "RIBD-END.DAT" and "RIBD-SEG.DAT". These are somewhat modified from Mark R. (...) (24 years ago, 1-May-00, to lugnet.cad.dev)
|
