|
|
 | | Re: L3PLiTE?
|
| John VanZwieten wrote... (...) A general analyzer may be a good idea. As you say, the optimized .dat file can be viewed in any rendering engine, and also, you can run L3P on it. Of course, the analyzer could be compiled into L3P, L3Lab, LDLite etc. (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
| | | | | Re: L3PLiTE?
|
| Leonardo Zide wrote... (...) I assume you have manually added extra info to all parts into your pieces.bin. Is there any chance you could export that info into some META commands to be inserted into each part in the LDraw PARTS base, so LDraw (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
| | | | | Re: Problem with 1-4con1.dat
|
| John VanZwieten wrote... (...) Is there any use for color 16 in linetypes 2 and 5? To test if we have any color 16 lines, I just added a warning to "L3P -check" The only legitimate example I could find was in PARTS\S\973p46a.dat.DAT "~Subpart (...) (25 years ago, 29-Mar-00, to lugnet.cad.dev)
| | | | | Re: What is BFC meta command ?
|
| (...) BFC means back face culling, it basically means that the rendering program doesn't need to draw the faces that are not facing the viewer (calculated by taking the dot product between a face normal and the camera direction). It's there to make (...) (25 years ago, 29-Mar-00, to lugnet.cad.dev)
| | | | | Re: Checking for bowtie quads?
|
| (...) Quads should be plane and follow a correct order, the points must be in a correct order. Search the old messages and you'll find several discussions about it. Leonardo (25 years ago, 29-Mar-00, to lugnet.cad.dev)
|
|
