 | | Re: OMR Submission and Storage
|
|
(...) Searching through a potential lot of messages for the word 'OMR.' (...) But posting a submission to an OMR group and casually posting to a sets group are in fact different. One there is strict requirements for, the other there isn't. So it (...) (25 years ago, 23-Jul-99, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: OMR Submission and Storage
|
|
(...) So do I. But I probably wouldn't subscribe to a sets or omr newsgroup by mail. It would work, but why not avoid possible confusion and go for 100% certainty on a completely new dedicated newsgroup? Some people might think that (...) (25 years ago, 23-Jul-99, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: OMR Submission and Storage
|
|
(...) Yes. Those that are non-instruction submodels but purely for ease of modelling are definitely acceptable. (I gotta remember to throw that one in the creation/submission guide) (...) Good thoughts. I would say that the models which do not (...) (25 years ago, 23-Jul-99, to lugnet.cad.dev.org.ldraw)
|
| |
| | About LDraw/LEdit Part 4212
|
|
I have been trying to acquire and use the car frame from #6390 Main Street & #6375 in LDraw. (URL) will note that it's different from the one in #6634, 6525, and other sets made after 1983. The bottom is smooth and cannot support a 2x4 plate (...) (25 years ago, 22-Jul-99, to lugnet.cad.dev)
|
| |
| | Re: OMR Submission and Storage
|
|
(...) of rotation. (...) haven't been (...) everyone else (...) do?? (...) Just how do you center it on the hinge part of a 1x2 hinge plate (:-I I have yet to figure out how to do that, so I guess that means I've got a pea-sized brain too. :) Ryan (25 years ago, 22-Jul-99, to lugnet.cad.dev.org.ldraw)
|
