| | Re: Discussion-Large Technic Shock 2909c01.dat
|
|
(...) Why not post it to dat.parts? -- Terry K -- (25 years ago, 13-May-99, to lugnet.cad.dev)
|
|
| | Re: 99-03 Voting: Quick Comments
|
|
(...) I wish I knew for a _fact_ that this is (was) the case, but I can't say so with any certainty. I would suppose that using an existing mold to create an axle, and then cutting threads into the element, makes a lot more sense than trying to (...) (25 years ago, 13-May-99, to lugnet.cad.dev)
|
|
| | Re: Working on Part 30384
|
|
Ok, I've made significant progress on this part (Thanks John! Thanks Steve!). In the process, I have made 3 "new" primitives (actually modifications of existing ones): 1-4con1 1-4ring3 1-4ring10 These were necessary to maintain the geometry, though (...) (25 years ago, 13-May-99, to lugnet.cad.dev, lugnet.cad.dat.parts)
|
|
| | Re: Working on Part 30384
|
|
Ok, I've made significant progress on this part (Thanks John! Thanks Steve!). In the process, I have made 3 "new" primitives (actually modifications of existing ones): 1-4con1 1-4ring3 1-4ring10 These were necessary to maintain the geometry, though (...) (25 years ago, 13-May-99, to lugnet.cad.dev, lugnet.cad.dat.parts)
|
|
| | Re: Cone primitives
|
|
(...) without (...) too, (...) The 3 refers to the inner radius of the cone. All cone primitives (like ring primitives) are made with an outer radius which is 1 LDU greater than the inner radius. So a con3.dat would have inner-radius 3 and outer (...) (25 years ago, 12-May-99, to lugnet.cad.dev)
|