 | | Re: LDGLite outputting gobble-dee-goo to terminal window
|
|
(...) Don, Here are some comments on the 7/23 version (built from the current.tgz time-stamped early this morning): * Solid part moving mode (-LE) works fine at lower resolutions. I think I tried all of the predefined views. Using -v1024,740 (a (...) (21 years ago, 24-Jul-03, to lugnet.cad.dev.mac)
|
| |
| | Re: LDGLite outputting gobble-dee-goo to terminal window
|
|
(...) Well that makes sense. The bug is worse. (...) Oh, again... sorry, I guess I should read the readme better. I had not noticed that the home and end keys were the keys that did the "out of plane" movements in the 1, 2, 3, 4, 5, and 7 views. In (...) (21 years ago, 24-Jul-03, to lugnet.cad.dev.mac)
|
| |
| | Re: GLUT 3.2
|
|
(...) Charles, thanks. This solution worked for me. (Sorry Chris, I posted in the ldglite thread before trying this out -- it worked much faster than I thought!) Perhaps the other error was dependent on the libForeground problem. Chris, since (...) (21 years ago, 24-Jul-03, to lugnet.cad.dev.mac)
|
| |
| | Re: LDGLite outputting gobble-dee-goo to terminal window
|
|
(...) Chris, thanks for the info. The pop-up menu had been working for me with the GLUT in GLUT.framework 2.2.8 (dated February 11). I got the same error trying to build GLUT from the sample code. --Tom (21 years ago, 24-Jul-03, to lugnet.cad.dev.mac)
|
| |
| | Re: LDGLite outputting gobble-dee-goo to terminal window
|
|
(...) Apparently yes, but it has the drawback you noticed below. (...) This is because from certain viewpoints two parallel edges exactly cover each other. In XOR math they cancel each each other out and the part disappears. The Stencil buffer (...) (21 years ago, 24-Jul-03, to lugnet.cad.dev.mac)
|
