 | | Re: Stud5 and type 5 lines at edge of cylinders. —Travis Cobbs
| | | | In lugnet.cad.dat.parts...rimitives, Paul Easter wrote: ... "mess" ... deleted :-) (...) have handled this incorrecly, I need to know so I can try to fix the (...) this page; (...) point hanging out in space should be tangent to the cylinder, that (...) (21 years ago, 2-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| | | | | | | | | | Re: Stud5 and type 5 lines at edge of cylinders. —Paul Easter
| | | | | (...) That's what I was afraid of... That is not how I handled it in the program. So, now this should apply for any segment files, right? 1-16,1-8,3-16,1-4,7-48, etc? If so, I will have to rethink how to calculate those points. now... this brings us (...) (21 years ago, 2-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| | | | | | | | | | | | Re: Stud5 and type 5 lines at edge of cylinders. —Travis Cobbs
| | | | | (...) I think ideally this would be used on all segmented primitives that are circular and not flat (obviously it doesn't apply to primitives like disks and rings). So think that the same logic would apply to cones. Incidentally, I think the 1/8 (...) (21 years ago, 3-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| | | | | | | | | | | | Re: Stud5 and type 5 lines at edge of cylinders. —Paul Easter
| | | | | (...) Ok, so... that could also mean torii as well... again, the primitive generator and past spreadsheets do this the "old" way. I will have to look into that as well. (...) I believe you are correct. (...) I agree. Should I make this an option on (...) (21 years ago, 8-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| | | | | | |
