Parts Primitives : 351


CAD / LDraw Files / Parts / Primitives / 351	350 \| 352

Subject:	Re: Stud5 and type 5 lines at edge of cylinders.
Newsgroups:	lugnet.cad.dat.parts.primitives
Date:	Fri, 15 Aug 2003 14:01:05 GMT
Viewed:	3405 times

In lugnet.cad.dat.parts.primitives, Mark Kennedy wrote: > I recently reworked the stud 5 primitive to make use of more quarter > cylinders. I then noticed that when viewed there were edge lines > apearing where they shouldn't. If you look at the primitive from > various points you can see this occur. Ahh, the dreaded S-curve cylinder join rears it's ugly head again. I voted to ignore this a while back and gave my reasons. http://news.lugnet.com/cad/dev/?n=7192 Nobody disagreed at the time. Don

Message has 2 Replies:

		Re: Stud5 and type 5 lines at edge of cylinders.
(...) So the problem could be solved by using high res primitives? I'll have to try that out. (21 years ago, 16-Aug-03, to lugnet.cad.dat.parts.primitives)

		Re: Stud5 and type 5 lines at edge of cylinders.
(...) Is there a reason that the cylinder primitives haven't been updated to work like the sphere primitive? As long as there are type 5 lines on both ends of each partial cylinder, and the control point out in space is tangent to the cylinder (...) (21 years ago, 17-Aug-03, to lugnet.cad.dat.parts.primitives)

Message is in Reply To:

		Stud5 and type 5 lines at edge of cylinders. [DAT]
I recently reworked the stud 5 primitive to make use of more quarter cylinders. I then noticed that when viewed there were edge lines apearing where they shouldn't. If you look at the primitive from various points you can see this occur. 0 Stud (...) (21 years ago, 15-Aug-03, to lugnet.cad.dat.parts.primitives)

10 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search