 | | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) Is there a reason that the cylinder primitives haven't been updated to work like the sphere primitive? As long as there are type 5 lines on both ends of each partial cylinder, and the control point out in space is tangent to the cylinder (...) (23 years ago, 17-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) So the problem could be solved by using high res primitives? I'll have to try that out. (23 years ago, 16-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) Ahh, the dreaded S-curve cylinder join rears it's ugly head again. I voted to ignore this a while back and gave my reasons. (URL) disagreed at the time. Don (23 years ago, 15-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Stud5 and type 5 lines at edge of cylinders. [DAT]
|
|
I recently reworked the stud 5 primitive to make use of more quarter cylinders. I then noticed that when viewed there were edge lines apearing where they shouldn't. If you look at the primitive from various points you can see this occur. 0 Stud (...) (23 years ago, 15-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: Torus Primitives on the Part Tracker
|
|
(...) Cool! (...) More cool! (...) the two related part files, neither of which is certified, I'd say go ahead and update t04q3333.dat. (...) Certainly. Steve (23 years ago, 6-Jul-03, to lugnet.cad.dat.parts.primitives)
|
