|
In lugnet.cad.dat.parts, Tore Eriksson wrote:
> Steve Bliss wrote:
>
> >
> > It's looking good. I think your mesh is fine.
>
> Thanks. :)
Just try not to make a mesh of things.
> > BTW, you can dissassemble a horse using a letter opener. The two halves
> > of the body are just friction-fit together, not permanently connected
> > (ie, they are not glued, cemented, nor welded). I think they use up an
> > entire tube of friction on each horse.
>
> Thanks for the hint, Steve. I'll give it a try. But if you're wrong, my daughter will not be too happy about you! :o)
I've taken two or three horses apart. Be a bit careful, to avoid
marring the edges where the two halves come together.
Steve
|
|
Message is in Reply To:
5 Messages in This Thread: ![Horse Progress Report -Tore Eriksson (7-Apr-00 to lugnet.cad.dat.parts)](/news/x.gif) ![](/news/246.gif) ![Re: Horse Progress Report -Steve Bliss (7-Apr-00 to lugnet.cad.dat.parts)](/news/x.gif) ![](/news/46.gif) ![Re: Horse Progress Report -Tore Eriksson (7-Apr-00 to lugnet.cad.dat.parts)](/news/x.gif) ![](/news/46.gif) ![You are here](/news/here.gif)
![](/news/x.gif) ![](/news/68.gif) ![Re: Horse Progress Report -Jeremy H. Sproat (7-Apr-00 to lugnet.cad.dat.parts)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|