Subject:
|
Re: Horse Progress Report
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 7 Apr 2000 19:25:29 GMT
|
Viewed:
|
2482 times
|
| |
|
|
Steve Bliss wrote:
>
> It's looking good. I think your mesh is fine.
Thanks. :)
>
> BTW, you can dissassemble a horse using a letter opener. The two halves
> of the body are just friction-fit together, not permanently connected
> (ie, they are not glued, cemented, nor welded). I think they use up an
> entire tube of friction on each horse.
Thanks for the hint, Steve. I'll give it a try. But if you're wrong, my daughter will not be too happy about you! :o)
/Tore
|
|
Message has 1 Reply:
 | | Re: Horse Progress Report
|
| (...) Just try not to make a mesh of things. (...) I've taken two or three horses apart. Be a bit careful, to avoid marring the edges where the two halves come together. Steve (25 years ago, 7-Apr-00, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Horse Progress Report
|
| (...) It's looking good. I think your mesh is fine. BTW, you can dissassemble a horse using a letter opener. The two halves of the body are just friction-fit together, not permanently connected (ie, they are not glued, cemented, nor welded). I think (...) (25 years ago, 7-Apr-00, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
