 | | Re: Is anyone working on 32745?
|
|
(...) Cool. We might actually get this very difficult part done. It may take a while but I'll try to get the inside bit mostly complete (easier than the outside). Then we can split the work into the harder bits... Tim PS. We should probaly shift to (...) (18 years ago, 28-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
(...) I have never done in this way, but it sounds good. I think first step should be a mokup for the overall dimensions and the connection (axle hole etc) points. The fine tuning (ribs in frontside etc) should then be divided into areas for you and (...) (18 years ago, 28-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
(...) Do you fancy a divide and conquer approach? If we each did different sections it might make it more possible. At the least it is a fairly easy part to subdivide. Tim (18 years ago, 28-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
(...) I wanted to start that part some month ago, but at a closer look I decided to not doing it because it is a real challenge. But I want that part very, very much. So please go ahead and make my dream come true. cu mikeheide (18 years ago, 27-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Is anyone working on 32745?
|
|
Hi all, Just thought I'd check to see if anyone was working on part 32475 ((URL) It's a horrid part to work on so I'm hoping someone has but realise it's probably unlikely. Thanks, Tim (18 years ago, 27-Mar-08, to lugnet.cad.dat.parts)
|
