Subject:
|
Re: Is anyone working on 32745?
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 28 Mar 2008 07:44:39 GMT
|
Viewed:
|
8820 times
|
| |
|
|
In lugnet.cad.dat.parts, Michael Heidemann wrote:
> In lugnet.cad.dat.parts, Timothy Gould wrote:
> > Hi all,
> >
> > Just thought I'd check to see if anyone was working on part 32475
> > (http://peeron.com/inv/parts/32475)? It's a horrid part to work on so I'm hoping
> > someone has but realise it's probably unlikely.
> >
> > Thanks,
> >
> > Tim
>
> I wanted to start that part some month ago, but at a closer look I decided to
> not doing it because it is a real challenge. But I want that part very, very
> much. So please go ahead and make my dream come true.
>
> cu
> mikeheide
Do you fancy a divide and conquer approach? If we each did different sections it
might make it more possible. At the least it is a fairly easy part to
subdivide.
Tim
|
|
Message has 1 Reply:
 | | Re: Is anyone working on 32745?
|
| (...) I have never done in this way, but it sounds good. I think first step should be a mokup for the overall dimensions and the connection (axle hole etc) points. The fine tuning (ribs in frontside etc) should then be divided into areas for you and (...) (17 years ago, 28-Mar-08, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Is anyone working on 32745?
|
| (...) I wanted to start that part some month ago, but at a closer look I decided to not doing it because it is a real challenge. But I want that part very, very much. So please go ahead and make my dream come true. cu mikeheide (17 years ago, 27-Mar-08, to lugnet.cad.dat.parts)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
