 | | 2951 repost —John Jensen
|
| | | discovered some errors ( I have now found out what "check it with l3p" means) there's still a little anoying bug. When I add it to my parts list and LDraw tries to make the bmp for the /vec dir. the 1-8disc's doesn't show up. They appear quite (...) (24 years ago, 21-Jan-00, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: 2951 repost —Fredrik Glöckner
|
| | | | | When looking at this part in LDLITE, it appears to me that a lower section of the cylinder and the disc (but not the edge) is missing. Does it look like that to you, too? Fredrik (24 years ago, 22-Jan-00, to lugnet.cad.dat.parts)
|
| | | | | |
| | | | | | | Re: 2951 repost —John Jensen
|
| | | | | | (...) Just checked (with different colors on the troublesome areas) and in LDLite (I'm using ver. 1.6) They show up, but in LDraw the 1-8disc's are missing, nothing wrong with the 1-8cyli parts though, you do have the hi-res primitives? This is very (...) (24 years ago, 22-Jan-00, to lugnet.cad.dat.parts)
|
| | | | | | |
| | | | | | | | Re: 2951 repost —Fredrik Glöckner
|
| | | | | | (...) Nah, I think that is why the part rendered wrongly on my system. Should grab the correct primitives! Sorry to bother you. Fredrik (24 years ago, 22-Jan-00, to lugnet.cad.dat.parts)
|
| | | | | | |
| | | | | Re: 2951 repost —Tore Eriksson
|
| | | | (...) Is it ok to use shashes and not backslashes in a pure DOS environment? I wouldn't recommend it, but then again, not too many run DOS nowadays? /Tore (24 years ago, 22-Jan-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: 2951 repost —John Jensen
|
| | | | (...) I was a bit pussled over this too, but I figure that LDraw is clever enough to figure it out for itself:) (changing / to \ doesn't solve my problem either btw.) But I have this nagging feeling that I'm missing something here... When putting (...) (24 years ago, 22-Jan-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: 2951 repost —Steve Bliss
|
| | | | (...) It should be sufficient to put the primitives in the proper location. There's nothing else that needs to be update. Steve (24 years ago, 24-Jan-00, to lugnet.cad.dat.parts)
|
| | | | |
