Subject:
|
Problem with part 30208.dat
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 10 Sep 2007 23:44:43 GMT
|
Viewed:
|
4525 times
|
| |
|
|
I recently CAD'd my Tequila Sunrise locomotive, which uses the part 30208.dat,
Cylinder 4 x 4 Hemisphere Multifaceted.
As you can see in the render, the part is overlapping the arch piece on the
boiler:
http://www.flickr.com/photos/savatheaggie/1338258406/
However, I built this locomotive in real life before I did it in Ldraw, and had
no issue with the arch piece:
http://www.flickr.com/photos/savatheaggie/500561395/
So would someone review the dimensions of the file in the Ldraw format versus
real life to make sure it is correct? I just downloaded the part from the Ldraw
website to make sure I didn't have some older version, but there was no change.
From what I can gather, the part is about a half plate too tall, and if I'm not
mistaken in real life two of these parts put end to end form a perfect
sphere/golf ball, but two in Ldraw look stretched and oblong.
--Tony
|
|
Message has 1 Reply:
 | | Re: Problem with part 30208.dat
|
| (...) Yep, I think you are right. The 30208.dat part appears to be 4 LDU too tall, unless there are more than one brick version of this part. Unfortunate, because to correct it will probably take a complete reworking of the part. -Matt :) ---...--- (...) (17 years ago, 11-Sep-07, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
