 | | Re: door 1 x 3 x 1 new patterns and errors in parts on PT
|
|
(...) That's not a problem. I may have to do a little bit of scaling so that the corners have integer coordinates, and that the pattern's centered. But shouldn't take much time or effort. And I'll check on the overlapping quads. John (21 years ago, 12-May-03, to lugnet.cad.dat.parts)
|
| |
| | POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT) [DAT]
|
|
Hi all: This message contains the subpart 3069bs18: POLICE pattern for 80's town sets. Notes: Corners of the pattern are X ±17 Y 0 Z ±5 giving the pattern overall dimensions of X 34 Y 0 Z 10 I cleared up the overlapping quads in the P, and verified (...) (21 years ago, 13-May-03, to lugnet.cad.dat.parts)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT) [DAT]
|
|
Whoops. I forgot to remove MLCAD's ROTATION meta commands, and to edit the name. Here's the real subpart, with correct heading. 0 ~POLICE Pattern 0 Name: s\3069bs18.dat 0 Author: John Riley <Rohnjiley@yahoo.com> 0 Unofficial Element 0 BFC CERTIFY (...) (21 years ago, 13-May-03, to lugnet.cad.dat.parts)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT)
|
|
(...) Personaly I'd suggest using ring primitives on the letters O and C to save space. (21 years ago, 13-May-03, to lugnet.cad.dat.parts)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT)
|
|
(...) Me, too. But there aint no rings with a x-radius-difference of 1 and z-radius-difference of 1.125. Or you need to have overlapping rings. Even using ndis, segm (chord) primitives and triangles filling up is not possible, because the outer (...) (21 years ago, 14-May-03, to lugnet.cad.dat.parts)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT)
|
|
(...) I think the O could be done with overlapping rings (and roughly 3/4 of the C), now that I think about it (I may try it before converting everything over to quads). But considering the C cannot be done without using quads, it may look odd that (...) (21 years ago, 14-May-03, to lugnet.cad.dat.parts)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT)
|
|
All, The POLICE pattern is now in Parts Tracker as 3069bs18.dat NOTES: Corner coordinates are X: ±17 Y: 0 Z: ±5 Also, I've updated a few parts (3822p09.dat for example) John (21 years ago, 17-May-03, to lugnet.cad.dat.parts)
|
