Subject:
|
Re: The Mummy (from "Adventurers" theme)
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 30 May 2002 20:31:42 GMT
|
Viewed:
|
4603 times
|
| |
|
|
In lugnet.cad.dat.parts, Steve Bliss writes:
> In lugnet.cad.dat.parts, Franklin W. Cain wrote:
>
> > The subfile for the leg(s) has gaps for the upper 2/3ds of the leg,
> > but the Mummy has printing on its *toes*. I've pretty much decided
> > that I'll need to make a new subfile, containing all the "inside"
> > stuff, and minus all of the "outside" stuff (including the toes).
> > Then, I can update the "original" subfile to reference this new
> > subfile, so as to minimize duplicated code (and wasted disk space).
> >
> > Comments?
>
> You should move the remaining 'outside front' surfaces from the leg
> subfiles to the blank main files, and update the existing printed-leg
> parts to match the changes. That requires updating 6 official files,
> and your 3 unofficial files.
>
> Actually, as long as you're in there, you c/should insert the commented
> code into the subfiles, for the front of the legs. Like the commented
> code found in s\973s01.dat.
>
> Steve
That sounds the best way to go. Great to see another minifig author.
Chris
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: The Mummy (from "Adventurers" theme)
|
| (...) You should move the remaining 'outside front' surfaces from the leg subfiles to the blank main files, and update the existing printed-leg parts to match the changes. That requires updating 6 official files, and your 3 unofficial files. (...) (24 years ago, 29-May-02, to lugnet.cad.dat.parts)
|
16 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
