Subject:
|
Re: Part x176
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 3 May 2002 01:46:56 GMT
|
Viewed:
|
2140 times
|
| |
|
|
In lugnet.cad.dat.parts, Steve Bliss writes:
>
> Do *not* use the Peeron 'x' numbers as the basis for LDraw parts! The
> two sets of numbers (LDraw and Peeron) are *not* synchronized. If you
> need a 3DN (three digit number, aka TPN, or temporary part number),
> email me. If you're going to be busy making new files, I can reserve a
> range of numbers for you.
>
> In this case, the official LDraw 176.dat is a '~moved-to' stub file.
> Eventually, we'll have to reuse the '~moved-to' stubs. But not yet.
>
> Ross, please use number x124 for this part.
Just tried, Steve, and x124 is now used by a minifig shield. Could you
reserve a block of 10 & email me?
Thanks
ROSCO
|
|
Message has 1 Reply:
 | | Re: Part x176
|
| (...) Argh! This is what comes of trying to run a world-wide subversive network single-handedly! Err, strike that. That was for some other newsgroups. Sorry about the bad suggestion. Your block of numbers is in the email. Steve (23 years ago, 3-May-02, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Part x176
|
| (...) Hey Ross: sorry I didn't really get the point of your email -- I was in a rush, and didn't look at the parts. Otherwise, I would have said then, what I'm going to say now. Do *not* use the Peeron 'x' numbers as the basis for LDraw parts! The (...) (23 years ago, 29-Apr-02, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
