Subject:
|
Re: Unofficial part: 2853 Technic Crankshaft
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 20 May 1999 06:13:18 GMT
|
Viewed:
|
988 times
|
| |
|
|
"John VanZwieten" <john_vanzwieten@email.msn.com> writes:
> When viewed from the left side, there is no edge line along the top of the
> "crank case". Changing the above line to:
> 1 16 -10 0 -20 0 0 -9 -9 0 0 0 10.2 0 2-4cyli.dat
> will solve this problem.
I have made this change, but I can't see how it makes any difference.
Could you elaborate slightly on the effect of this, please?
Fredrik
|
|
Message has 1 Reply:
 | | Re: Unofficial part: 2853 Technic Crankshaft
|
| Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m390ak8e0x.fsf@....uio.no... (...) The 2-4cyli.dat has a conditional line at the "begining" of the curve, but not one at the end. I assume this is so that if two 2-4cyli's are (...) (26 years ago, 20-May-99, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Unofficial part: 2853 Technic Crankshaft [DAT]
|
| Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3d7zydchl.fsf@....uio.no... (...) When viewed from the left side, there is no edge line along the top of the "crank case". Changing the above line to: 1 16 -10 0 -20 0 0 -9 -9 0 (...) (26 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
