LEGO Elements/Parts : 3482


CAD / LDraw Files / Parts / 3482	3481 \| 3483

Subject:	Re: Two questions on primitives
Newsgroups:	lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives
Date:	Thu, 28 Mar 2002 08:02:02 GMT
Viewed:	2051 times

> 1.) I've noticed the new BFC complient primitives on the Parts Tracker. How > are we going to resolve the fact that the cylindar primitve can be used as > both outside and inside surfaces. The only way I see is to have 2 diffent > primitives, one for outside applications and one for inside uses. The INVERTNEXT directive takes care of this problem. Quoted from BFC proposal: "INVERTNEXT This option inverts a subfile. It may only be used immediately before a subfile command line, and it only influences the immediately following subfile command." Philo www.philohome.com

Message has 1 Reply:

		Re: Two questions on primitives
(...) I'm concerned that if we release those primitives that can be used as both inside and outside surfaces as BFC complient, we'll have to go back to all the other pieces that use them to insert the INVERTNEXT directive (where appropriate). (...) (23 years ago, 29-Mar-02, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives)

Message is in Reply To:

		Two questions on primitives
Two questions (if these have already been discussed, just direct me to the appropriate LUGNET post): 1.) I've noticed the new BFC complient primitives on the Parts Tracker. How are we going to resolve the fact that the cylindar primitve can be used (...) (23 years ago, 28-Mar-02, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives)

10 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search