 | | New Part: 168135s01.dat - Sticker Technic Supercar 4x4x4 Logo —Imre Papp
|
| | | Dear list, I prepared the first sticker for the 8880 Technic Supercar set. ( The rough scans of the stickers can be viewed here: (URL) Joshua informed me the sticker sheet of this set bears the number 168315, so according to the subpart naming (...) (23 years ago, 4-Feb-02, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: New Part: 168135s01.dat - Sticker Technic Supercar 4x4x4 Logo —Steve Bliss
|
| | | | | (...) Looks good! (...) I'm ok with all of these points. There doesn't seem to be a problem with bleed-thru at normal resolution (at least, L3Lab doesn't have a problem), so the 1LDU-thick box is OK. (...) Instead of a three-character suffix, drop (...) (23 years ago, 5-Feb-02, to lugnet.cad.dat.parts)
|
| | | | | |
| | | | | Re: New Part: 168135s01.dat - Sticker Technic Supercar 4x4x4 Logo —Steve Bliss
|
| | | | | One question I forgot to pose: Since this file includes a direct copy of the LEGO trademark logo, should it have a copyright notice/disclaimer in the code? Steve (23 years ago, 5-Feb-02, to lugnet.cad.dat.parts)
|
| | | | | |
| | | | | | | Re: New Part: 168135a.dat - Sticker Technic Supercar 4x4x4 Logo —Imre Papp
|
| | | | | | I made some modification: 1. Changed the filename as Steve suggested. 2. Reduced the thickness (thinness? :-))of the thin box to 0.25 LDU as Bernd Broich suggested. In L3Lab it did'nt cause any bleed-through. 3. Included a placeholder in the part (...) (23 years ago, 6-Feb-02, to lugnet.cad.dat.parts)
|
| | | | | | |
| | | | | | | | Re: New Part: 168135a.dat - Sticker Technic Supercar 4x4x4 Logo —Steve Bliss
|
| | | | | | (...) Hmm. I opened this in LDLite 2.4, put it into 'twirl mode', and there was some serious bleedthru at various (odd) angles. I didn't try twirling the original (1LDU-high) file. LDraw and LEdit handled the file just fine. But I didn't try to (...) (23 years ago, 6-Feb-02, to lugnet.cad.dat.parts)
|
| | | | | | |
| | | | | Re: New Part: 168135s01.dat - Sticker Technic Supercar 4x4x4 Logo —Bernd Broich
|
| | | | Hi all, (...) I think the height of the box can be 0.2-0.25 LDU (0.2 is the minimum I tested in some LCAD-programs), this is in the near of the real thickness of the stickers. (...) I also have a lot of stickered parts and want to make them, but I (...) (23 years ago, 5-Feb-02, to lugnet.cad.dat.parts)
|
| | | | |
