 | | Unofficial part: 2853 Technic Crankshaft [DAT]
|
|
0 Technic Crankshaft 0 Name: 2853.DAT 0 Author: Fredrik Glöckner 0 Un-Official Element 0 Note that this part is probably "impossible" to make properly in LDraw 0 right now. See the discussion at 0 (URL) 1 16 -10 0 -9.8 0 0 -1 -1 0 0 0 29.8 0 (...) (26 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2853 Technic Crankshaft [DAT]
|
|
Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3d7zydchl.fsf@....uio.no... (...) When viewed from the left side, there is no edge line along the top of the "crank case". Changing the above line to: 1 16 -10 0 -20 0 0 -9 -9 0 (...) (26 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2853 Technic Crankshaft
|
|
(...) I have made this change, but I can't see how it makes any difference. Could you elaborate slightly on the effect of this, please? Fredrik (26 years ago, 20-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2853 Technic Crankshaft
|
|
Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m390ak8e0x.fsf@....uio.no... (...) The 2-4cyli.dat has a conditional line at the "begining" of the curve, but not one at the end. I assume this is so that if two 2-4cyli's are (...) (26 years ago, 20-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2853 Technic Crankshaft
|
|
(...) I understand now. Thanks for sharing the info! Fredrik (26 years ago, 21-May-99, to lugnet.cad.dat.parts)
|
