Subject:
|
Re: New part, need a part number.
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 20 Feb 2001 08:46:49 GMT
|
Viewed:
|
919 times
|
| |
|
|
Ronald:
Looks ok, but at least one of the lines marking the change
from horizontal to vertical is missing.
Play well,
Jacob
|
|
Message has 2 Replies:
 | | Re: New part, need a part number. [DAT]
|
| Hmm, I see what you were refering to, I think. If I am not too mistaken, the original part I started with were missing these as well. Check it out again if you don't mind. :) Oh, how do I get a part number for this? (...) 0 Author : Ronald Scott (...) (24 years ago, 20-Feb-01, to lugnet.cad.dat.parts)
| | | Re: New part, need a part number. [DAT]
|
| Ok, I figured it out. The original part used the rect.dat primitive which I replaced (I'm a neophite) with a quadrilateral. Soooo, I redid it again with a RECT.DAT instead of the quarilateral the way the original was and maybe this is more correct? (...) (24 years ago, 20-Feb-01, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | New part, need a part number. [DAT]
|
| I made this part by editing 4854.dat Slope 45 4 x 4 Double Inverted. I needed this part to build a MLcad version of the TIE Fighter. I need a part number for this. Also, I am sure that it will need some error checking. 0 Author : Ronald Scott Moody (...) (24 years ago, 20-Feb-01, to lugnet.cad.dat.parts)
|
10 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
