Subject:
|
Re: New Part: 2x2 round tile with imperial logo
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 25 Oct 2000 12:53:34 GMT
|
Viewed:
|
909 times
|
| |
|
|
> Are you drawing this part "by eye" or measuring, or working from a scan?
> Scanning it in and then blowing up the scan to really high resolution may be
> a good way to get the dimensions closer.
Actually, I'm drawing it from memory, which isn't working quite as well as I
hoped it would (I've got the set that it's from, but it's in storage right
now). I'm sure that if I had a part or a good close-up pic or scan that I
could work from it would be a much better job. In fact... that pic of the
train should be plenty to get me much closer to the mark.
Thanks
|
|
Message has 1 Reply:
 | | Re: New Part: 2x2 round tile with imperial logo
|
| (...) Standard accepted practice in the parts authoring community is to *not* do this. That is, don't draw parts you don't actually have in front of you. That pic I posted is enough to tell that a part is "wrong" but not enough to tell that a part (...) (24 years ago, 25-Oct-00, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: New Part: 2x2 round tile with imperial logo
|
| (...) Whoops, sorry about that! Well, I think it needs more work then. I can't find a really definitive picture, but if you look here: (URL) scroll to the roof view: (URL) will see that the black outer circle is significantly less than the tile (...) (24 years ago, 25-Oct-00, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
