To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dat.partsOpen lugnet.cad.dat.parts in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / LDraw Files / Parts / 1249
  Re: New Part: Cylinder 2 x 2 x 2/3 Inverted Dome
 
(...) Why not set the part so the top is at Y=0? This would move the part down 16LDU, if I read the DAT correctly. (...) I echo this sentiment. Very nice job. Steve (24 years ago, 14-Jun-00, to lugnet.cad.dat.parts)
 
  Re: New Part: Cylinder 2 x 2 x 2/3 Inverted Dome
 
(...) Yes, given that this part has no studs at all, it is probably best to move it down under the X-Z-plane. Good point! Fredrik (24 years ago, 15-Jun-00, to lugnet.cad.dat.parts)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR