Subject:
|
Re: New Part: Cylinder 2 x 2 x 2/3 Inverted Dome
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 15 Jun 2000 10:40:07 GMT
|
Viewed:
|
1261 times
|
| |
|
|
Steve Bliss <blisses@worldnet.att.net> writes:
> Why not set the part so the top is at Y=0? This would move the
> part down 16LDU, if I read the DAT correctly.
Yes, given that this part has no studs at all, it is probably best to
move it down under the X-Z-plane. Good point!
Fredrik
|
|
Message is in Reply To:
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
