 | | Re: Need part number for a dangerous predator
|
|
(...) Thanks! The edge lines I put in for Ldraw's and MLcad's sake; they make it easier to see the important features of the cat's face, plus the edge along the bottom I think is important to preserve. In POV-Ray of course they vanish, though. I (...) (24 years ago, 25-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Need part number for a dangerous predator
|
|
(...) I think it's a pretty amazing first part! Nice work. I'm not sure about use of the edge lines on things like the eyes, etc. These get lost when you POV. If there really are marks or grooves in the part there, you may want to try to model them. (...) (24 years ago, 25-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Need part number for a dangerous predator
|
|
(...) Sounds like this is not the part number. Many parts have numbers of the form "n nn" or "n-nn" which probably refer to indivudual sites within the injection mould. Only the larger ones have room to include the TLC part number, typically in the (...) (24 years ago, 25-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Need part number for a dangerous predator
|
|
(...) Interesting... I never noticed the part numbers before. On the cat, all I can see is some writing in the stud hole underneath: (c) LEGO 1 07 That 7 might be a 1; it's very hard to tell because it's at the very edge. However 1 07 as far as I (...) (24 years ago, 25-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Need part number for a dangerous predator
|
|
(...) Welcome!!! I just looked at the cat part. Pretty good for a first part! But i can not help you with the part number, Although it should be printed some where on the part. Any how, welcome as a member to the CAD Community. C-Ya!! --Austin (24 years ago, 25-Feb-01, to lugnet.cad.dat.parts)
|
