Subject:
|
Re: m3723 MiniFigure Sculpture (version 1)
|
Newsgroups:
|
lugnet.cad.dat.models.sets
|
Date:
|
Tue, 7 Aug 2001 04:43:29 GMT
|
Viewed:
|
2221 times
|
| |
|
|
In lugnet.cad.dat.models.sets, Gary Williams writes:
> I noticed the left arm overhangs the legs by two
> studs, while the right arm overhangs by one stud.
I admit it was hard to align the arms in to the sockets properly, but I'm
not quite sure what you mean. They both do overhang but they're not equal as
they should be? I'll have to check that out...
> Also, one minor nit, I think the standard is to have models facing the -Z
> direction for consistency. I think your rendition is facing +X. Just
> rotate everything 90 degrees clockwise. :)
yes, you're right. I chose +X facing to match the instruction booklet.
Thanks for the comments! Let us know when your Ollie is ready!
-- Robert
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: m3723 MiniFigure Sculpture (version 1)
|
| "Robert Graff" <mrgraff@tvi.cc.nm.us.no.spam> wrote in message news:GHCu52.Iur@lugnet.com... (...) fix, (...) together so (...) not (...) I just loaded these DAT files into GWCAD (the CAD program I'm writing) for speed/stress testing. I noticed the (...) (23 years ago, 6-Aug-01, to lugnet.cad.dat.models.sets)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
