 | | Re: Straight moving with only one rotation sensor [DAT]
|
|
I' built a similar bot, but the wheels are free-turning. Additionaly, the wheels are pressed down, so that they always have contact to the floor. It's a soccer bot for the RoboCup Junior event. 0 Untitled 0 ROTATION CENTER 0 0 0 1 "Custom" 0 (...) (22 years ago, 13-Jun-04, to lugnet.cad.dat.ideas)
|
| |
| | Re: Straight moving with only one rotation sensor
|
|
Hello y'all- Does anyone out there know where I can get discontinued lego sets (mainly the autochassis set 8860&65) at reasonable rates here in Ontario? Thanks. (22 years ago, 10-Jun-04, to lugnet.cad.dat.ideas)
|
| |
| | Straight moving with only one rotation sensor [DAT]
|
|
Hi I saw in the LEGO Mindstorms Web Page that many people made their robots with 2 motors go straight using one rotation sensor on each wheel and stopping the correct motor until both sensors were equal. I got Ultimate Accessory Set as a present (...) (22 years ago, 10-Jun-04, to lugnet.cad.dat.ideas)
|
| |
| | Re: Problem with click hinge part(s)?
|
|
(...) my click hinges, and the lugs are ALL closer to the top of vertical end wall than the bottom. The position of the lug in your new version is definitely incorrect. Whether thats a problem with the primitive or the sub-part I don't know, but it (...) (22 years ago, 10-Jun-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Problem with click hinge part(s)?
|
|
(...) Actually its the other way about. 30387 is wrong. More accurately, the subpart s/30387s01.dat does not match the guidance notes in p/clh1 and p/clh4. 0 // Placement on side of bricks; rotate accordingly, 0 // place on side 10 Ldu below top (...) (22 years ago, 9-Jun-04, to lugnet.cad.dat.parts, FTX)
|
