Subject:
|
Re: Basic Part missing
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 15 Dec 2002 13:59:02 GMT
|
Viewed:
|
488 times
|
| |
|
|
In lugnet.cad, Steven Lane writes:
> While using MLCAD just now I found a very basic part missing from the
> library namely the technic pulley. Not the six hole one but the one thats
> one brick wide with an axle hole.
Hello Steven, I think you mean this part: 3482 - Wheel Centre Large
see: http://img.lugnet.com/ld/3482.gif
> It wasn't this piece I was actually after but rather the spoked version with
> a round centre hole but the previously mentioned part would be an acceptable
> stand in.
The following part is probably an even better substitute, since it has a
round (technic) centre hole also: 6248 - Wheel Freestyle
see: http://img.lugnet.com/ld/6248.gif
With friendly greetings, M. Moolhuysen.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Basic Part missing
|
| While using MLCAD just now I found a very basic part missing from the library namely the technic pulley. Not the six hole one but the one thats one brick wide with an axle hole. It wasn't this piece I was actually after but rather the spoked version (...) (22 years ago, 15-Dec-02, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
