Subject:
|
Basic Part missing
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 15 Dec 2002 13:43:28 GMT
|
Viewed:
|
431 times
|
| |
|
|
While using MLCAD just now I found a very basic part missing from the
library namely the technic pulley. Not the six hole one but the one thats
one brick wide with an axle hole.
It wasn't this piece I was actually after but rather the spoked version with
a round centre hole but the previously mentioned part would be an acceptable
stand in.
If someone could make this part I'd be very appreciative :-).
Steve
|
|
Message has 2 Replies:
 | | Re: Basic Part missing
|
| (...) Hello Steven, I think you mean this part: 3482 - Wheel Centre Large see: (URL)It wasn't this piece I was actually after but rather the spoked version with (...) The following part is probably an even better substitute, since it has a round (...) (22 years ago, 15-Dec-02, to lugnet.cad)
| | | Re: Basic Part missing
|
| (...) By the way, I believe that THIS particular part is listed as a yet unofficial LDraw part file: 30155 in the LDraw.org Parts Tracker. See: (URL) read (URL) before you use any of these unofficial parts. With friendly greetings, M. Moolhuysen. (22 years ago, 15-Dec-02, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
