Subject:
|
Re: Launching LDraw from LDAO
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 9 Feb 1999 17:42:50 GMT
|
Viewed:
|
704 times
|
| |
|
|
I take you figured out how to convince LDAO to run on your system...
As for LDraw freezing, is there any error message? Does a window come
up at all?
There are some general PIF-setting hints in LDAO's readme.txt. There
are also some trouble-shooting suggestions at the James Jessiman
Memorial. Have you tried any of those?
Steve
On Tue, 9 Feb 1999 15:18:33 GMT, "Eric Brok" <brok@fcjsvc.hvu.nl> wrote:
> When I launch LDraw from LDAO it freezes. When I run it by itself it runs
> ok.
> Any ideas what may be wrong?
>
> I run NT.
>
> TIA,
>
> Eric Brok
>
>
|
|
Message has 1 Reply:
 | | Re: Launching LDraw from LDAO
|
| Steve Bliss wrote in message <36c072ba.17255060@l...et.com>... (...) Yes, it involved becoming a local NT administrator and all.. (...) I played around with it for a while; may not have tried them all yet. E.g. I succeeded to launch LDlite instead (...) (26 years ago, 10-Feb-99, to lugnet.cad)
|
Message is in Reply To:
| | Launching LDraw from LDAO
|
| When I launch LDraw from LDAO it freezes. When I run it by itself it runs ok. Any ideas what may be wrong? I run NT. TIA, Eric Brok (26 years ago, 9-Feb-99, to lugnet.cad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
