Computer Aided Design : 8504


CAD / 8504	8503 \| 8505

Subject:	Re: My cutter is almost ready : ) - mounting the cannon
Newsgroups:	lugnet.cad, lugnet.cad.dat.models, lugnet.cad.dat.models.sets, lugnet.pirates
Date:	Sun, 18 Aug 2002 18:14:09 GMT
Viewed:	5567 times

in Set #6291 the Cannon is mounted thus: put one turntable 4x4 (3403,3404) on top of two Bricks 1x4 with Groove (2653, grooves turned inwards) into the grooves you insert one plate 2x8, on it two Hinge Plate 1 x 4 with Car Roof Holder (4315, roof holders pointing outwards to fit into the grooves) Arne Berlin

Message is in Reply To:

		Re: My cutter is almost ready : )
(...) I usually put a cannon on the poop deck using a 4x4 turntable. You may want a plate underneath so the cannon clears the studs on the railing. It works best if the turntable overhangs the poop deck by one stud (forward). Then you can still (...) (22 years ago, 6-Aug-02, to lugnet.cad, lugnet.cad.dat.models, lugnet.cad.dat.models.sets, lugnet.pirates)

4 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search