Subject:
|
Question about BFC
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 9 Jul 2002 14:20:58 GMT
|
Viewed:
|
341 times
|
| |
|
|
Dear All,
Before I sent my first part to you
(http://news.lugnet.com/cad/dat/parts/?n=4052) I tried to verify its
conformity with BFC. During this investigation I found out that sub-part
s\3069bs01.dat, which I used in my patterned part, is actually not BFC
compliant. Main problem I think is primitive box5.dat. It is certified, but,
in my opinion, only for exterior of a brick. In that mentioned sub-part box5
should be inverted "inside out" to make sub-part BFC certified.
Is there any other solution to certify that sub-part then creating another
box5 with opposite winding?
Are there any plans to certify all parts already released but not certified yet?
Regards
Marek Idec
|
|
Message has 1 Reply:
 | | Re: Question about BFC [DAT]
|
| (...) Oooh! Lemmee answer! Steve B was kind enough to help me out on pretty much this exact question a few days ago. If you use the statement: 0 BFC INVERTNEXT 1 16 0 0 0 40 0 0 0 -24 0 0 0 20 box5.dat 0 the box will be visible from within, but not (...) (22 years ago, 9-Jul-02, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
