Special:
|
[DAT] (requires LDraw-compatible viewer)
|
Subject:
|
Re: Question about BFC
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 9 Jul 2002 14:28:21 GMT
|
Viewed:
|
360 times
|
| |
|
|
In lugnet.cad, Marek Idec writes:
> Dear All,
>
> Before I sent my first part to you
> (http://news.lugnet.com/cad/dat/parts/?n=4052) I tried to verify its
> conformity with BFC. During this investigation I found out that sub-part
> s\3069bs01.dat, which I used in my patterned part, is actually not BFC
> compliant. Main problem I think is primitive box5.dat. It is certified, but,
> in my opinion, only for exterior of a brick. In that mentioned sub-part box5
> should be inverted "inside out" to make sub-part BFC certified.
> Is there any other solution to certify that sub-part then creating another
> box5 with opposite winding?
> Are there any plans to certify all parts already released but not certified yet?
Oooh! Lemmee answer! Steve B was kind enough to help me out on pretty
much this exact question a few days ago. If you use the statement:
0 BFC INVERTNEXT
1 16 0 0 0 40 0 0 0 -24 0 0 0 20 box5.dat
0
the box will be visible from within, but not from the outside.
I think that's the answer. Someone please correct me if I'm wrong.
Dave!
(when did this BFC stuff start, anyway?)
|
|
Message has 2 Replies:
 | | Re: Question about BFC
|
| (...) Ding ding ding! Points for Dave! (...) It all started in a small village, far away in a forgotten mountain... Steve (22 years ago, 10-Jul-02, to lugnet.cad)
| | | Re: Question about BFC
|
| (...) Thanks a lot, Dave! I've just send to Steve new, modified by me, 3069bs01.dat to Steve. I hope that I didn't make any mistake and my version of that file is BFC compliant. Marek (22 years ago, 10-Jul-02, to lugnet.cad)
|
Message is in Reply To:
| | Question about BFC
|
| Dear All, Before I sent my first part to you ((URL) I tried to verify its conformity with BFC. During this investigation I found out that sub-part s\3069bs01.dat, which I used in my patterned part, is actually not BFC compliant. Main problem I think (...) (22 years ago, 9-Jul-02, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
