Subject:
|
Re: Aluminum 2x4 bricks
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 8 Apr 2002 20:23:02 GMT
|
Viewed:
|
740 times
|
| |
|
|
In lugnet.cad, Bram Lambrecht writes:
> Franklin W. Cain writes:
> Those are the dimensions I did use, Franklin :) However, those
> dimensions are NOT accurate to .001 inch. And that discrepancy
> apparently makes a significant difference in the connection properties
> of the part.
I did some measurements a little over a year ago. I didn't write it up as
well as the "long wall" post referenced by Larry, but here you go:
http://news.lugnet.com/cad/?n=5284
Note also that I didn't measure temperature (it was "room temperature" or
so), nor did I look into interbrick gap.
--
Tony Hafner
www.hafhead.com
|
|
Message is in Reply To:
 | | RE: Aluminum 2x4 bricks
|
| (...) Those are the dimensions I did use, Franklin :) However, those dimensions are NOT accurate to .001 inch. And that discrepancy apparently makes a significant difference in the connection properties of the part. --Bram Bram Lambrecht (...) (23 years ago, 5-Apr-02, to lugnet.cad)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
