Subject:
|
Re: newbie problem
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 22 Aug 2000 07:10:41 GMT
|
Viewed:
|
546 times
|
| |
|
|
Andy Lynch wrote...
> I have been having some success with these tools, until I tried to render only
> one (1) LDraw part in POVRay. If I try to render only 1 part, then the part
> comes out gray, instead of the color that it shows up in MLCad. If I add
> another part, without changing the first in any way, they both come out their
> proper colors. The first part that I tried this with was the Fruit Tree, and
> then I tried it with the Pine Tree 4 x 4 x 6 2/3, so I went and tried to
> render a simple 2 x 4 red brick with the same result, it came out gray. Then
> I added another part, and they both came out correct.
Use the -c option to specify another default color than gray.
See also http://news.lugnet.com/cad/?n=3471
/Lars
|
|
Message has 1 Reply:
 | | Re: newbie problem
|
| Thanks Lars, This clears things up for me. -Andy Lynch ----- Original Message ----- From: "Lars C. Hassing" <lch@ccieurope.com> (...) render only (...) part (...) add (...) their (...) Tree, and (...) Then (...) (24 years ago, 22-Aug-00, to lugnet.cad)
|
Message is in Reply To:
| | newbie problem
|
| Hi all, Ok. I'm a newbie and have just been using these tools for a short time. I have run into a tiny little problem, and I was wondering if someone could tell me what I am doing wrong. Tools I am using: MLCad 1.9r4 L3P and L3PAO POV-Ray I have (...) (24 years ago, 21-Aug-00, to lugnet.cad)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
