Subject:
|
Re: mlcad request
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 1 Aug 2000 05:25:27 GMT
|
Viewed:
|
1108 times
|
| |
|
|
Ok, I will have a look at it too....
Michael
Rui Martins <Rui.Martins@link.pt> schrieb in im Newsbeitrag:
Pine.GSU.4.10.10007311139020.615-100000@is-sv...
> On Mon, 31 Jul 2000, Michael Lachmann wrote:
> > Ok,
> >
> > your wish is heared :-) ... means I will implement something for it ...
>
> While you are at it, you could also make the resize(SPLIT) information of • the
> design windows (the ones with the views TOP, FRONT, RIGHT, 3D)
> relative. Since currently if you resize them, and if after you MAximize • it, or
> or vice-versa, only the setup were you resized gets the same • proporcionality.
>
> Sugestion: Keep a value between 0 and 1 (percentage) for the center X and • Y
> position, ans save it has you already do, but save the relative value, • then just
> resize the window according with the X and Y percentages.
>
> I' asking this, because I find it a little bit annoying !
>
> Thanks in advance, for any future improvement.
>
> See ya
>
> Rui Martins
>
|
|
Message is in Reply To:
 | | Re: mlcad request
|
| (...) While you are at it, you could also make the resize(SPLIT) information of the design windows (the ones with the views TOP, FRONT, RIGHT, 3D) relative. Since currently if you resize them, and if after you MAximize it, or or vice-versa, only the (...) (24 years ago, 31-Jul-00, to lugnet.cad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
