Subject:
|
Re: Mockup Part 30117 Panel 10 x 10 x 2 & 1/3 Corner
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 19 Jun 2000 17:19:19 GMT
|
Viewed:
|
972 times
|
| |
|
|
In lugnet.cad, Karim wrote:
> In lugnet.cad.dat, Steve Bliss writes:
> > Here's a half-finished UFO quarter-hull. It's a mess, and something is
> > definitely not right--
>
> Steve,
>
> There is a problem with this mock-up part (I know, I know.. its
> half-finished :)) in the actual file... It works in LEdit, but when I try
> to render it using LDlite, it scrambles the last 10% of the part...
>
> More importantly, LDlite will ALWAYS draw this part in one particular
> orientation, regardless of how/where it is used in the model... very
> strange... LDLite renders the whole model up to the point of this piece, and
> then clears the view and renders the part in a 0,0,0,1,0,0,0,1,0,0,0,1
> conifguration, so no matter how complicated the model is, all i get is a
> drawing of this single part in default position...
Hmmm. Try editing your 30117.dat file with a text editor. Make sure the
line 0 FILE 30117.dat does *not* appear in the file (it would be near the
top, if anywhere).
Also, look at the bottom 10% of the file, to see if the formatting is
messed up. You might use LDAO's Editor, set the "Stop at Cursor" option,
and click your way down the file until you find the bad code.
Steve
|
|
Message is in Reply To:
 | | Re: Mockup Part 30117 Panel 10 x 10 x 2 & 1/3 Corner
|
| (...) Steve, There is a problem with this mock-up part (I know, I know.. its half-finished :)) in the actual file... It works in LEdit, but when I try to render it using LDlite, it scrambles the last 10% of the part... More importantly, LDlite will (...) (24 years ago, 17-Jun-00, to lugnet.cad)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
