Subject:
|
Re: LDAO and NT
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 30 Nov 1998 13:16:34 GMT
|
Viewed:
|
2439 times
|
| |
|
|
Ah, it sounds like it's not an NT issue, but a system issue.
But it is partially my fault. The install program is probably set to
always update the various system files (the default, and incorrect,
setting). I will make sure the install procedure only updates that
file (and the other system files) if necessary. I'm not sure if I can
tell the install program to continue if it can't update a file, but
I'll check.
I'll keep you updated on this.
Steve
Once upon a time, "Eric Brok" <brok@fcjsvc.hvu.nl> wrote:
>
> Steve Bliss wrote in message <365c1669.7291044@lugnet.com>...
> > Once upon a time, "Eric Brok" <brok@fcjsvc.hvu.nl> wrote:
> >
> > > LDAO doesn't run on Windows NT, does it?
> > > Is there an easy fix/workaround?
> >
> > It should run fine on NT (for awhile, I could only *compile* it under
> > NT). What problem are you having?
> >
> > Steve
>
> Installation procedure fails because file Oleaut32.dll cannot be opened.
> Suppose the admin doesn't allow this.
>
> Eric
>
>
|
|
Message is in Reply To:
 | | Re: LDAO and NT
|
| Steve Bliss wrote in message <365c1669.7291044@lu...et.com>... (...) Installation procedure fails because file Oleaut32.dll cannot be opened. Suppose the admin doesn't allow this. Eric (26 years ago, 26-Nov-98, to lugnet.cad)
|
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
