Subject:
|
Advice please on 4.5V motor part authoring
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 22 Nov 1999 13:33:10 GMT
|
Viewed:
|
319 times
|
| |
|
|
I have made a good start on modelling the 4.5V motor as a DAT file (hope I've
not stolen this from anyone else - but the Parts Tracker seems to be
out-of-action). I would appreciate some advice from experienced part authors on
how best to proceed. The visible exterior of the motor obviously comprises 3
parts -
1. the casing
2. an insert which includes the 1x2x1 connector block end
3. the spindle with cog
Should I model these as separate (but incomplete parts - leaving the hidden
surfaces missing) or build just one DAT file for the composite ?
Chris
|
|
Message has 2 Replies:
 | | Re: Advice please on 4.5V motor part authoring
|
| (...) I'm not very familiar with the 4.5V electrics. Did the motor only come in gray/black, or were there multiple colors available? For the three motors already modeled, one was done with multiple parts, the others as a single part. So there's no (...) (25 years ago, 22-Nov-99, to lugnet.cad)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
