Subject:
|
Re: My first DAT file!
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 31 Oct 1999 20:05:17 GMT
|
Viewed:
|
355 times
|
| |
|
|
In lugnet.cad.dat, Larry Pieniazek writes:
> Well, actually an MPD. If this works right, it's a model of my yellow and
> black Hydrogen Tanker.
>
> This car has been around a while, since I got my AucZILLA VII winnings, I think
> it was, which included a bazillion yellow 1x1 round bricks...
Nicely done, Larry. John III recognized it by about the 4th step. When do we
get to see some of those awesome locomotives?
To answer your question about rotation steps: a rotation step only rotates the
camera angle for writing instructions (and only works for MLCad). It's
different from the LDLite command "0 ROTATE" which actually rotates the
position of pieces in the model. Since rotation step only applies to camera
angles, it will have no effect on L3P or POV-Ray.
Keep lcad'in!
-John Van
|
|
Message has 2 Replies:
 | | Re: My first DAT file!
|
| John VanZwieten wrote ... (...) the (...) camera (...) I think it is unfortunate that MLCad uses the same "0 ROTATE" command as LDLite. Other parsers (like L3P :) may get confused. L3P can skip 0 ROTATE 180 0 0 REL 0 ROTATE 90 0 0 ABS 0 ROTATE 10 0 (...) (25 years ago, 1-Nov-99, to lugnet.cad, lugnet.cad.dev)
| | | Re: My first DAT file!
|
| (...) See my second model... posted to lugnet.cad.dat.models You may have to cut-n-paste the model out and look at it in MLCad though as LDLite gets stuck close to the end. I would really like to know what the issue is there... it makes me loath to (...) (25 years ago, 2-Nov-99, to lugnet.cad, lugnet.cad.dev)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
