Subject:
|
Service release (1.82) of BlockCAD
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 11 Sep 1999 14:03:13 GMT
|
Viewed:
|
1470 times
|
| |
|
|
OK, a service release of BlockCAD is available at:
http://user.tninet.se/~hbh828t/bce182.zip
It's just the BLOCKCAD.EXE, so you must have BC 1.8 installed already.
It solves John's problems #1 and #3.
Keep the bug reports coming!
--
Anders Isaksson, Sweden
BlockCAD: http://user.tninet.se/~hbh828t/proglego.htm
Gallery: http://user.tninet.se/~hbh828t/gallery.htm
> John VanZwieten skrev i meddelandet ...
> > Since you asked, I had three problems.
> >
> > 1. When adding a column of 2x2 rounds, if I clicked too fast, it put • multiple
> > copies of the bricks at the same x,y,z coordinates. This was particularly
> > annoying when I went to move the column, only to find that the extra bricks
> > were still there.
> >
> > 2. Sometimes in the oblique view pieces further away will show over closer
> > pieces.
> >
> > 3. In oblique view, I had some trouble selecting pieces (the 2x2 rounds,
> > actually.) I would point at the 2x2 round and click, but it would select • some
> > piece further away (and under a bunch of other bricks, which really messes
> > things up.
|
|
Message is in Reply To:
 | | Re: Note from BlockCAD author
|
| John VanZwieten skrev i meddelandet ... (...) multiple (...) This one's new to me (perhaps I'm too slow :-) - I'll look into it (when time permits). (...) Yep, there are many situations when the 'view order' sorting goes a bit wrong. Most of the (...) (27 years ago, 10-Sep-99, to lugnet.cad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
