Subject:
|
Re: 6L technic sloped piece
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 10 Nov 1998 15:33:00 GMT
|
Viewed:
|
3570 times
|
| |
|
|
Moz (Chris Moseley) wrote in message ...
> Selçuk <teyyareci> <sgore@nospam.superonline.com> wrote
> > Fredrik Glöckner wrote in message ...
> > > I believe I found the answer myself by looking at the LDraw parts file.
> > > If I'm not mistaken, the angle is
> > > arctan(32/78) = 22.3°
>
> > Absolutely right. It is axactly 22 degrees and 29 minutes. (with 1 minute
> > precision)
>
> Um, 0.3 degrees is 18 minutes not 29. Unless Fredrik meant 30 minutes...
>
> Moz
Oh, sorry about that, I just figured out this after my posting, But this is
what my quality control technician measured on a projection measurment
device.
Selçuk
|
|
Message is in Reply To:
 | | Re: 6L technic sloped piece
|
| Selçuk <teyyareci> <sgore@nospam.superonline.com> wrote (...) Um, 0.3 degrees is 18 minutes not 29. Unless Fredrik meant 30 minutes... Moz (26 years ago, 10-Nov-98, to lugnet.cad)
|
7 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
