Subject:
|
Re: 6L technic sloped piece
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 10 Nov 1998 05:44:58 GMT
|
Viewed:
|
3691 times
|
| |
|
|
Selçuk <teyyareci> <sgore@nospam.superonline.com> wrote
> Fredrik Glöckner wrote in message ...
> > I believe I found the answer myself by looking at the LDraw parts file.
> > If I'm not mistaken, the angle is
> > arctan(32/78) = 22.3°
> Absolutely right. It is axactly 22 degrees and 29 minutes. (with 1 minute
> precision)
Um, 0.3 degrees is 18 minutes not 29. Unless Fredrik meant 30 minutes...
Moz
|
|
Message has 1 Reply:
 | | Re: 6L technic sloped piece
|
| Moz (Chris Moseley) wrote in message ... (...) Oh, sorry about that, I just figured out this after my posting, But this is what my quality control technician measured on a projection measurment device. Selçuk (26 years ago, 10-Nov-98, to lugnet.cad)
|
Message is in Reply To:
| | Re: 6L technic sloped piece
|
| Fredrik Glöckner wrote in message ... (...) Absolutely right. It is axactly 22 degrees and 29 minutes. (with 1 minute precision) regards Selçuk (26 years ago, 9-Nov-98, to lugnet.cad)
|
7 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
